So, you won't see all the really cool stuff that's in this series elastic set of 14 actuators, each one which has its own capability to sense temperature and pressure.

MAWP for heating cooling system _ bar kPa gauge

(b) the lowest set pressure of the pressure limiting device(s)

Design reference temperature means the temperature at which the vapour pressure of the contents is determined for the purpose of calculating the MAWP.

(b) the allowable tolerance at the discharge pressure for spring loaded devices

Robotic Air Powered Hand with Elastic Ligaments.

(a) the pressure (in bar or kPa) or temperature (in C) at which it is set to discharge

When no spring loaded pressure relief device is used, the frangible disc shall be set to rupture at a nominal pressure equal to the test pressure.

TPO temperature of peroxide at relieving conditions 100 C

(c) the reference temperature corresponding to the rated pressure for frangible discs

TPO temperature of peroxide formulation at relieving conditions K

6.6.2.10.1 Fusible elements shall operate at a temperature between 110 C and 149 C on condition that the pressure in the shell at the fusing temperature will be not more than the test pressure.

It changes with temperature and with barometric pressure.

TPO temperature of peroxide at relieving conditions K

(c) the reference temperature corresponding to the rated pressure for frangible discs and

This type of round uses a pyrotechnically initiated (PIE) fuze. It works by the impact of the round rapidly crushing explosive materials causing the materials to explode.

4.2.1.13.10 Vacuum relief devices and spring loaded valves shall be provided with flame arresters.

Very hostile environments, 150 C, 10,000 PSI.

the partial pressure (in bar) of air or other gases in the ullage space being determined by the design reference temperature and the liquid phase expansion due to the increase of the mean bulk temperature of tr tf (tf filling temperature, usually 15 C, tr 50 C maximum mean bulk temperature).

A country with a higher elasticity of greenhouse gas emissions would therefore share a lower burden in greenhouse gas emission limitation.

6.6.4.6.1 Every shell shall be provided with not less than two independent spring loaded pressure relief devices.

T absolute temperature in Kelvin ( C 273) above the pressure relief devices in the accumulating condition

This assumption is also supported by the fact that the vapour pressure of hot NaK (753 K) equals that of water at room temperature (293 K).

(ii) the partial pressure (in bar) of air or other gases in the ullage space being determined by a maximum ullage temperature of 65 C and a liquid expansion due to an increase in mean bulk temperature of tr tf (tf filling temperature, usually 15 C tr 50 C, maximum mean bulk temperature).

In addition, thermography3 has been used to study the heat emission from warheads and components.

6.6.3.7.1 Portable tanks shall be provided with one or more spring loaded pressure relief devices.

Frangible discs not in series with a spring loaded pressure relief device are not permitted.

Here's how to do it at room temperature and pressure, using non toxic materials.

(ii) the partial pressure (in bar) of air or other gases in the ullage space being determined by a maximum ullage temperature of 65 C and a liquid expansion due to an increase in mean bulk temperature of tr tf (tf filling temperature usually 15 C tr 50 C maximum mean bulk temperature) and

E elasticity of fuel consumption used for space heating in relation to heating degree days (between 1 and 0.5)

Spring loaded relief devices shall be used to achieve the full relief capacity prescribed.

The meteorological rockets observe temperature, atmospheric pressure, wind etc. at altitudes of between 30 and 60 kilometres.

6.6.2.11.1 Except as specified in 6.6.2.8.3, frangible discs shall be set to rupture at a nominal pressure equal to the test pressure throughout the design temperature range.

As far as light weapons are concerned, the situation is slightly different, owing to the higher pressures of the stronger charges fired. The strain on essential parts of the weapon, such as barrels, bolts and receivers, is much greater.

The temperature and pressure in the test vessel are recorded during the entire experiment.

The Police Riot Squad, as well as the Papua New Guinea Defence Force (PNGDF), both sent to deal with the situation, reportedly resorted to brutal and illegal ways to contain the strife.

Both features would tend to reduce the hazard posed by armed missiles sitting on the ground especially when fitted with piezoelectrically initiated fuzes.

The pressure relief devices shall have sufficient capacity to prevent rupture of the shell due to over pressurization or vacuum resulting from filling, discharging, or from heating of the contents.

And that's in the up position. When you step on it, either by remote control or with the pressure of your foot, it will fire you, depending on the gas pressure, anything from five feet to 30 feet.

Calculate the molar mass of the gas.

Emergency pressure relief devices may be of the spring loaded, frangible or fusible type.

6.6.3.5.5 In addition to filling, discharge and gas pressure equalizing orifices, shells may have openings in which gauges, thermometers and manometers can be fitted.

And to make that, it involves extremes of temperature, extremes of pressure and loads of pollution.

64. High pressure synthetic routes to the production of diamonds have been known for about 50 years.

Apparently, Mrs. De Winter broke the cupid herself and forgot to say anything about it.