6.2.4.2.2.3 Testing of the aerosol dispensers after filling

Each filled aerosol dispenser shall be subjected to a test performed in a hot water bath or an approved water bath alternative.

6.2.4.2.2.2 Pressure and leak testing of aerosol dispensers before filling

Each filled aerosol dispenser shall be weighed and leak tested.

If the contents are sensitive to heat or if the aerosol dispensers are made of plastics material which softens at this test temperature, the temperature of the bath shall be set at between 20 C and 30 C but, in addition, one aerosol dispenser in 2000 shall be tested at the higher temperature.

Water's pumped from the lake and is filtered and shot as a fine mist through an array of high pressure fog nozzles, 35,000 of them. And a weather station is on the structure.

Spray

Spraycan

6.2.4.2 Aerosol dispensers

Sprays graffiti

You could do the same with a space spray.

These trials involved munitions supplied by the Iraqi chemical weapons programme and an aerosol spray device modified specifically for the biological weapons programme.

These include inadequate or insufficient sprinkler and smoke detection systems and storage of documents and paper too close to sprinklers.

There's one with a fragrance dispenser.

You saw the spray going in.

Or you could spray.

6.2.4.2.1.1 The temperature of the water bath and the duration of the test shall be such that the internal pressure reaches that which would be reached at 55 C (50 C if the liquid phase does not exceed 95 of the capacity of the aerosol dispenser at 50 C).

You create a spray of detergent.

L2 For UN 1950 aerosols, the large packaging shall meet the Packing Group III performance level.

If any aerosol dispenser shows evidence of leakage at a rate equal to or greater than 3.3 10 2 mbar.l.s 1 at the test pressure, distortion or other defect, it shall be rejected.

Then the spray dries. It turns into powder.

(f) a means for control of non conforming aerosol dispensers

Click or drag to spray graffiti.

When he bent down to pick it up it exploded.

Two smoke ejectors next door to them.

6.2.4.2.1 Hot water bath test

6.2.4.3 With the approval of the competent authority, aerosols and receptacles, small, containing pharmaceutical products and non flammable gases which are required to be sterile, but may be adversely affected by water bath testing, are not subject to 6.2.4.1 and 6.2.4.2 if

Water based sunblock with a strong penetration is often applied to oily skin. Sunscreen spray is also a good choice.

While doing so, he noticed an apparently empty aerosol can beside the dustbins and decided to throw it away with the other rubbish.

Experiments in water management focus on the development of water harvesting techniques, the promotion of desalination plants and dam construction.

This is the lowest level that can be measured in laboratory tests.

Anything in italics that starts with if is intended to be an explanatory note for the application of the Precautionary Statements and is not intended to appear on the label.

And the tiny water crystals here now look for all the world like they are frozen droplets of salty water, which is a discovery that suggests that not only do the jets come from pockets of liquid water, but that that liquid water is in contact with rock.

Did you ever use any chemical sprays or insecticides?

The environmental affects may include diurnal temperature cycling, vibration, shock, humidity, solar radiation, precipitation, sand dust, salt spray and electromagnetic radiation.

6.2.4.2.1.2 No leakage or permanent deformation of an aerosol dispenser may occur, except that a plastic aerosol dispenser may be deformed through softening provided that it does not leak.

That ain't water, Kid. Salt.

SP191 Delete may be considered as similar to aerosols except that they in the first sentence.

c. Saline water intrusion or

You can spray the problem is there are environmental issues.

Attempts to acquire specific spray dryers also failed for the same reason.

Poisons Centres and or medical practitioners or specialist advice should be sought in such situations and included on labels.

Aerosol dispenser fillers and component manufacturers shall have a quality system.

I can't make head or tail of it.

Salina, Kansas.