Minimum test pressure (bar)

(b) has a minimum burst pressure of 4 times the charge pressure at 20 C

(iii) Pressure sensors, pressure activated mechanisms, should, where possible, be subject to a minimum pressure force appropriate for the intended target.

4.1.3.6.3 Unless otherwise indicated, pressure receptacles having a minimum test pressure of 0.6 MPa shall be used.

(iii) Pressure sensors shall, where possible, be subject to a minimum pressure force appropriate for the intended target.

(h) A decrease of the maximum allowable working pressure, or maximum working pressure, not affecting thickness

In Table 1, in the heading of column 13, replace Working pressure, bar with Maximum working pressure, bar

4.2.4.2.2 For substances of Classes 3 to 9, the portable tank instructions (T1 T34) indicate the applicable minimum test pressure, the minimum shell thickness (in reference steel), bottom opening requirements and pressure relief requirements.

Pressure drums shall have a minimum wall thickness as specified by the competent authority.

TP14 The minimum test pressure shall not be less than 1.5 times the vapour pressure at 65 C or 10 bar, whichever is greater.

You know, one is just working without pressure.

(c) two thirds of the minimum test pressure specified in the applicable portable tank instruction in 4.2.4.2.6

Vents from the pressure relief devices, when used, shall deliver the relieved vapour or liquid to the atmosphere in conditions of minimum back pressure on the relieving device.

(b) the minimum thickness determined in accordance with the recognized pressure vessel code including the requirements in 6.6.3.3.

(b) the minimum thickness determined in accordance with the recognized pressure vessel code including the requirements in 6.6.4.3.

(b) the minimum thickness determined in accordance with the recognized pressure vessel code including the requirements in 6.6.2.3 and

Vents or pipes from the pressure relief device outlets, when used, shall deliver the relieved vapour or liquid to the atmosphere in conditions of minimum back pressure on the relieving devices.

59. The minimum standards regarding safety and healthy working conditions are imperative.

The minimum test pressure for portable tanks intended for specific substances is specified in the applicable portable tank instruction in 4.2.4.2.6

2 Domestic regulations of every State shall fix a minimum working age, as well as working conditions and hours.

UN No. Non refrigerated liquefied gases Max. allowable working pressure (bar) Small Bare Sunshield Insulated

Pipework to vent the vapour or liquid from the outlet of the pressure relief devices, when used, shall deliver the relieved vapour or liquid to the atmosphere in conditions of minimum back pressure on the relieving device.

Maximum allowable working pressure (MAWP) means the maximum effective gauge pressure permissible at the top of the shell of a loaded portable tank in its operating position including the highest effective pressure during filling and discharge

The minimum wage is determined for the lowest skilled labour in full time normal working conditions.

Working with the Harvard Business School, you'll see this example when you talk about minimum payment

6.6.2.12.1 The spring loaded pressure relief device required by 6.6.2.8.1 shall have a minimum cross sectional flow area equivalent to an orifice of 31.75 mm diameter.

20. The Special Representative is working to mobilize public opinion and political pressure against this terrible trend.

Spanish associations working in solidarity with the Saharan cause had had some success, resisting pressure exerted on them.

Maximum allowable working pressure (MAWP) means a pressure that shall be not less than the highest of the following pressures measured at the top of the shell while in operating position

The minimum or suitable (if it is acceptable to use a vent size larger than the minimum vent size) IBC or tank vent area, AIBC or Atank (m2), can be calculated using the minimum or suitable orifice vent area as tested in the 10 litre test at which the maximum pressure during venting is

With effect from 1 January 1995 the minimum length of the statutorily prescribed holidays amounts to 24 working days.

The law recognized several important principles, such as the fixation of minimum rates of wages, the introduction of a legally defined working day, the minimum age of employment and the concept of tripartism.

The purpose of establishing the minimum monthly wage is to guarantee at least the survival minimum to all employees those working in the private sector, as well as those employed in the public sector.

Moreover, the Department in question was already working with the minimum possible resources and any further redeployment would paralyse its activities.

Pressure

Pressure

PRESSURE

Pressure

Pressure?

Design pressure means the pressure to be used in calculations required by a recognized pressure vessel code.

Test pressure means the maximum gauge pressure at the top of the shell during the pressure test

Thus, the fixing of the minimum age at 15 was a decision made under the pressure of consensus and in no way reflected massive opposition to raising the age limit for recruitment.

A standardized minimum reorbit distance value should be determined by taking into consideration factors such as perturbation effects by the gravitational force of the Sun and the Moon and solar radiation pressure.

The main factor influencing the amount of the minimum monthly wage is the possibilities of the national budget that determine the increase in the minimum monthly wage of employees working at institutions financed from the national budget.

61. No category of workers and employees is excluded from the purview of the minimum standards regarding safety and healthy working conditions.